ACCURATE, SAFE AND ON-TIME DELIVERY
Technical status inspection of rotary tiller before use
Nov 08,2022
(1) The thickness of the cutting edge of the blade should be 0.5-1.5 mm, and the curve of the cutting edge should be smooth. If the cutting edge has defects, the depth should be less than 2 mm, and each knife should not have more than two defects. The blade must be firmly installed on the blade seat, and there should be locking measures to prevent it from loosening and causing personal accident or damage to the machine.
(2) After the knife is rolled into the rotary tiller, the gap between the top of the blade and the cover should be 30-45 mm. When the gap is too large, the block is easily thrown back to the front of the knife shaft to be cut again, wasting power; hours, it is easy to cause blockage. If this gap is less than 28 mm, the cover needs to be refitted.
(3) After the blade is rolled onto the rotary tiller, it should be checked for idling. Make the rotary tiller slightly off the ground, connect the power take-off shaft, rotate the rotary tiller at low speed, and observe whether its various components are running normally, such as whether the entire blade roll is running smoothly, whether there is any abnormality such as friction.
(4) When installing the universal joint assembly between the tractor and the rotary tiller, the square shaft and the clamping fork of the square shaft sleeve must be on the same plane to ensure the transmitted rotational speed is stable.
Other blog
Contact us
Our mission doesn't end with a project coming into production, and our team strives to use our know-how to provide a lifetime of quality service to our customers
Address: ChengBei Development Zone, Hechuan District. ChongQing
